Mobius 5-Bay Power Supply Replacement Instructions
-
On the back of the unit, remove the 6 screws on the left and right edges.
-
On the bottom of the unit, remove the 4 screws on the edges.
-
Place the Mobius upright.
-
Slide the shell off by holding the front section with one hand and pulling straight back on the shell with the other.
- Turn the Mobius upside down. There is a screw under 3 of the 4 feet and one screw in the middle of the bottom face, remove all 4 of these screws. *Do not completely pull off the feet. Only peel them back far enough to expose the screw.*
- Turn the Mobius upright. With one hand, hold the back plate (the black one) steady so it will not move. With the other hand, pull the rest of the Mobius away. *You should be able to see the power supply and PCB fully at this point.*
-
Unscrew the voltage selector switch from the back plate.
-
Disconnect all other wires from the power supply, leaving the calbes attached to the Mobius, not the power supply.
-
Remove the power supply by removing the 4 screws in the corners.
-
Install the new power supply and screw it in place.
-
Reconnect all cables and screw in the voltage selector switch to the back plate.
-
Silde the Mobius back together and re-screw it together.
-
Screw on the shell.